Torque all bolts to specifications in a circular pattern starting from the center bolts and working out to the ends. You can now put the same intake manifold on your Mustang that comes equipped from the factory on a 2012 Ford Mustang Boss 302. The studs will keep the intake from sliding on the RTV surface and will properly align the manifold to the heads The studs will be removed after some of the intake bolts are in place. Place the intake on the engine using 4 alignment studs screwed first into the heads. BK-3401 M50 M52 M54 Billet Intake Manifold 90mm with Fuel Rail kit and Throttle Body se. This is a view of the rear intake seal with a thick bead of RTV and the intake gaskets after coating them with a thin layer of RTV. This will make for a 100% seal once the manifold is placed on the engine. Coat ALL mating surfaces on the bottom of the intake manifold, including the end seal areas, with a paper thin layer of RTV. With average Horsepower Gains of 58RWHP & 40ft-lbs of torque, the Ford Racing BOSS 302 Intake manifold will definitely add some punch to your 2011+ Mustang. Once the gasket is glued to the head, apply a paper thin layer of RTV to the surface of the intake gasket that will fit against the intake manifold.Ĭlean the intake mating surfaces thoroughly. The adhesive will stick immediately,so be sure you get the gasket in the right spot the first time. Once the paper thin layer of adhesive has completely dried, THEN place the gasket onto the heads. Adds up to 61 HP and 43 ft-lbs of Torque Original Manifold Found on BOSS 302 Light-Weight Composite Construction Stealth. That tab is designed to hook over the head gaskets. Buy Ford Small Block SBF Dual Plane Air Gap Aluminum Intake Manifold 289 302 5.0 From Karl Kustoms, One Of The Largest Online Retailers Of Chevy Performance. Additional recommended parts are 1 each of the following OEM Ford. Compatible with Ford Small Block 260 289 302 (Late 351W) OEM and Aftermarket Intake Manifolds These are High Grade 18-8 (304) Stainless-Steel 12ea 5/16×2.0 Bolts and SS Washers That will NOT rust or Corrode like the chrome or steel ones sold. Notice the tab on the bottom of the intake gasket. Hardware to adapt BOSS 302 Intake Manifold onto Vortech Supercharged 11-14 5.0L Engine. Do the same on the heads where the gaskets will mate up. There are different sizes of intake gaskets for 289/302/5.0/351W engines.Ī mismatch will cause a major water leak!Īpply a paper thin layer of black weatherstrip adhesive or gasket adhesive on the “head” side of the intake gaskets. Be sure the water ports on each end of the gaskets are properly sized. Performer RPM 260/289/302 Intake Manifold Edelbrock 71213 Non-EGR - 1500-6500rpm - Air-Gap 302 - 65-66 Ford 289-302 cid - For 4 bbl Carb - Black Finish from.

302 intake manifold